Edge Trimming Bit (#491027)

D = 12.7mm, NL = 25mm

Cylindrical cutter for routing with templates. Edge trimming cutter with ball bearing below - this allows coatings in and on panel edges to be flush cut. Because of the small ball bearing, even inner radii of 15 mm can be flush cut.

Dowel Drilling Bit (#491066)

D = 5mm, NL = 30mm

A special cutter for dowel drillings in conjunction with a router. Thanks to its geometry, it is perfectly suited to high speeds. With brad point. The centring point offers the cutter very good guidance. In conjunction with the hole drilling system, a series of drill holes is quickly and easily created.

Groove Cutting Bit (#490959)

D = 10mm, NL = 20mm

With hard-wearing drill point. Ideal for cutting grooves, rebating and long-hole routing, and working with templates.

Groove Cutting Bit (#490969)

D = 18mm, NL = 30mm

With hard-wearing drill point. Ideal for cutting grooves, rebating and long-hole routing, and working with templates.

Roundover Bit (#491009)

D = 16.7mm, NL = 9mm, R = 2mm

Can be used with a 12.7mm ball bearing for rounding and with a 9.5mm ball bearing for routing a decorative cornice.

Roundover Bit (#491013)

D = 25.5mm, NL = 13.5mm, R = 6.35mm

Can be used with a 12.7mm ball bearing for rounding and with a 9.5mm ball bearing for routing a decorative cornice.

Roundover Bit (#491015)

D = 31.7mm, NL = 16.5mm, R = 9.5mm

Can be used with a 12.7mm ball bearing for rounding and with a 9.5mm ball bearing for routing a decorative cornice.

45-degree Chamfer Bit (#491025)

D = 36mm, NL = 11.5mm

With 12.7 mm ball bearing. Chamfer cutter can be used with or without a ball bearing.

Slot Cutting Bit (#491059)

D = 40mm, d = 6mm, NL = 4mm

For use either without ball bearing, or with a ball bearing of 16mm or 28mm.

15-degree Dovetail Bit (#490992)

D = 13.8mm, NL = 13.5mm

For producing a semi-covered dovetail joint SZ 14.