To add the Stationary Emergency Button to the account using the Partner Portal:

1. Log into the Partner Portal.
2. Find the customer account.
3. Click Equipment.
4. Click Sensors.
5. In Sensor Management, click Add a Sensor.
6. For Sensor ID, enter an unused ID.
7. For Zone Definition, select 15 (Emergency) or 26 (Non-Emergency).
8. For Sensor Name, enter a name for the sensor.
9. For Serial Number, enter the serial number found on the bottom of the device.
10. Click Add Sensor.

Installation and testing

1. Locate the sensor within 100 feet of the base station.
2. Check the button for any visible defects or damage. If damage is visible the unit should be replaced.
3. Locate the button on a flat surface in a visible location in the room.
4. If the button is new, pull out the plastic battery tab located on the underside of the unit. The tab is not needed for use and can be discarded.
5. If the audio message is not needed, ensure the On/Off switch is set to the “Off” position.
   
   Note: This switch does not turn off the unit or disable the wireless signaling; it only disables the audio message. This switch is located on the circuit board inside the unit.
    
6. The button can be mounted on a wall by removing the rubber feet on the bottom and sticking to the wall with double-sided foam tape.